KEYSIGHT U3817A ການວັດແທກພະລັງງານຄວາມຖືກຕ້ອງຂອງ IoT ແລະເຊັນເຊີ MEMS ດ້ວຍຊຸດຝຶກອົບຮົມແລະແຜ່ນຫ້ອງທົດລອງ
• University subjects: IoT systems, Embedded systems, IoT device management, IoT sensors technologies, Advanced IoT
• Years of study: Second to final year undergraduates
• Prerequisites(s): Basic programming, Electronic Circuits, Digital Circuits
Recommended instruments/software for lab setup:
- 34465A Digital Multimeter – Digital multimeter with 2M memory, digitizing and auto calibration
- DSOX1204G Oscilloscope - 70/100/200 MHz, 4 Analog Channels, with a built-in Waveform Generator
- N6705C DC Power Analyzer - Modular System Based on DC Power Supply or Electronic Load Outputs
- N6781A 2-Quadrant source - Source/Measure Units (SMUs) Modules
- X8712AD Event detector X8712AS – IoT and analysis software
Lab sheets
1. Setup the U3810A
2. Advanced Digital Communication Serial, SPI and USB
3. MEMS Sensors for Inertial Measurement and Pressure
4. Characterizing IoT Static and Dynamic Power Consumption
5. Evaluating Dynamic Current Drain and Battery Life
6. Characterizing a Solar Panel and Incorporating Solar Power in an IoT Device
7. Techniques for Optimizing Sensor Power Consumption and Efficiency
8. Event-based Dynamic Power Measurement
A1. Comparing Two Methods of Altitude Measurements with IoT Sensors
A2. Design a Solar-Powered Wireless Temperature Sensor
ຮັບສ່ວນຫຼຸດພິເສດຕາມປະລິມານ, ອັບເດດລາຄາຂາຍສົ່ງ ແລະ ການແຈ້ງເຕືອນສິນຄ້າໃໝ່ສົ່ງກົງເຖິງອິນບັອກຂອງທ່ານ.
ໂດຍການສະໝັກສະມາຊິກ, ທ່ານຍອມຮັບ ເງື່ອນໄຂການໃຫ້ບໍລິການ ແລະ ນະໂຍບາຍຄວາມເປັນສ່ວນຕົວ ຂອງພວກເຮົາ.
ເຂົ້າເຖິງຜູ້ຊ່ຽວຊານທີ່ໄດ້ຮັບການຢັ້ງຢືນຂອງພວກເຮົາໂດຍກົງ