ຮັບສ່ວນຫຼຸດພິເສດຕາມປະລິມານ, ອັບເດດລາຄາຂາຍສົ່ງ ແລະ ການແຈ້ງເຕືອນສິນຄ້າໃໝ່ສົ່ງກົງເຖິງອິນບັອກຂອງທ່ານ.
ໂດຍການສະໝັກສະມາຊິກ, ທ່ານຍອມຮັບ ເງື່ອນໄຂການໃຫ້ບໍລິການ ແລະ ນະໂຍບາຍຄວາມເປັນສ່ວນຕົວ ຂອງພວກເຮົາ.
ເຂົ້າເຖິງຜູ້ຊ່ຽວຊານທີ່ໄດ້ຮັບການຢັ້ງຢືນຂອງພວກເຮົາໂດຍກົງ
Power: 9V battery, continuous use time is about 70 hours.
Measure mode: Non-contact clipping method
Wire position: The measured wire is in the center of the jaw
Frequency: 50Hz/60Hz Automatic Identification
Live electricity range: AC70~1000V
Measuring the highest voltage: AC1000V
Clamp wire size: Outside diameter: ø1.5mm~ø48mm
Display:
[Positive phase] 4 phase detector lights are turned on in a clockwise direction;
[Reverse phase] 4 phase detection lights are turned on counterclockwise;
[Live electricity] L1, L2, L3 lights in the voltage setting range;
[Lack of phase] L1 or L2 or L3 lights are not lit;
[Open circuit] L1 or L2 or L3 lights are not lit
Beep:
[Positive phase] The instrument emits intermittent short beep;
[Reverse phase] The instrument emits a continuous long beep.
Battery check: After the power is turned on, the power indicator is on; the battery is low; the LOW BATTERY lamp is on.
Clamp lead length: 0.6m
Instrument size: L117.6mm×W 81mm×T 25mm
Automatic shut-down: After about 6 minutes of power on, the meter automatically shuts down to reduce battery consumption.
Battery voltage: When the battery voltage drops to about 5.2V, the battery voltage is low symbol to remind to replace the battery
Instrument weight: Instrument:260g (including battery)
Maximum rated power: 300mVA
Insulation strength: 3.7kVrms
